Motor Machine & Supply

Write a Review619-474-9366

CLOSED NOW - Opens at 8:00am

MM&S did a total head and block rebuild for my seized 95 Integra LS. They picked up the engine from curbside, did the work in about 1 week, and their work and parts were flawless - aAll for about $950: including 3-angle valve job, new valve stems, redecking head, welding & remachining crank, oversized rebore, redecking, new pistons, rings, bearings, conrods, oil pump, gasket set, and probably more I am forgetting.

Highly recommended!

This place did the impossible for me. I needed a STANDARD size piston for my 95 Jeep Cherokee 2.5L. I had already had 2 failed attempts (1 from ebay and 1 from Kragen) both were oversized and there was no standard single piston anywhere.



I resorted to using my old cracked piston until I could find one. Both the gentlemen there refused to put my rod back on that cracked piston and went OUT OF THEIR WAY to find me one. I left it there. By the end of the day, by some miracle, they were able to find me one. Incredible!!!! It only cost me $40 including the rod installation.



I will definitely go back to these guys! They really are the best.

I got my cylinder head resurfaced and cleaned for $40 and was done in less than two hours. Easy parking I highly recommend this place.